加权
信号(编程语言)
波峰系数
能量(信号处理)
谐波传动
角位移
波形
谐波
声学
谐波分析
计算机科学
控制理论(社会学)
a计权
时域
角速度
信号处理
工程类
故障检测与隔离
探测理论
物理
基质(化学分析)
振动
总谐波失真
数学
频域
锯齿波
极坐标系
信噪比(成像)
作者
H. Wang,Yu Guo,Xingchao Yin,Xin Chen,Zhile Wang
标识
DOI:10.1177/14759217261478589
摘要
Harmonic drives are widely used in industrial robots. However, due to the flexspline’s high contact ratio and the elastic deformation, conventional signal processing, such as synchronous averaging, struggle to extract information about flexspline tooth faults. To address this issue, this article proposes an instantaneous angular speed (IAS) signal energy-difference weighting (EDW) method for flexspline fault detection. First, the IAS signal is calculated by the outputs from the built-in encoder, and synchronous averaging is performed to reduce aperiodic components by using the full repeating cycle of the flexspline relative motion as the reference. Second, the energy difference weighting matrix is created using two angular positions separated by one quarter of the input cycle, with higher weights as signed to locations with greater energy variation. Third, a polar energy spectrum in the angular domain is introduced to depict the angular waveform and its energy distribution. The energy map is compared to the installation orientation of the defective flexspline, and the IAS signal’s crest factor (CF) is compared before and after EDW processing. These results support the use of the proposed method to detect flexspline tooth breakage and provide an interpretable representation.
科研通智能强力驱动
Strongly Powered by AbleSci AI