Secretion and Transcriptional Regulation of the Latex-Clearing Protein, Lcp, by the Rubber-Degrading Bacterium Streptomyces sp. Strain K30

About 22,000 1-methyl-3-nitro-1-nitrosoguanidine- and UV-induced mutants of the rubber-degrading bacterium Streptomyces sp. strain K30 were characterized for the ability to produce clear zones on natural rubber latex overlay agar plates. Thirty-five mutants were defective solely in cleavage of rubber and were phenotypically complemented with the wild-type lcp (latex clearing protein) gene. Sixty-nine mutants exhibited a pleiotropic phenotype and were impaired in utilization of rubber and xylan, indicating that the enzymes responsible for the initial cleavage of these polymers are exported by the same secretion pathway (Q. K. Beg, M. Kapoor, L. Mahajan, and G. S. Hoondal, Appl. Microbiol. Biotechnol. 56:326-3381, 2001; U. K. Laemmli, Nature 227:680-685, 1970). Analysis of the amino acid sequence encoded by lcp revealed a twin-arginine motif, indicating that Lcp is a substrate of the twin-arginine translocation (Tat) pathway (K. Dilks, W. Rose, E. Hartmann, and M. Pohlschröder, J. Bacteriol. 185:1478-1483, 2003). A tatC disruption mutant of Streptomyces lividans 10-164 harboring lcp from Streptomyces sp. strain K30 was not capable of forming clear zones on rubber overlay agar plates. Moreover, Lcp and enhanced green fluorescent protein fusion proteins were detected in the supernatant. Using Escherichia coli having the twin-arginine motif in the signal peptide upstream of Lcp, clear evidence that Lcp is secreted was obtained. Transcriptional analysis revealed basal expression of Lcp in glucose-grown cells and that transcription of lcp is obviously induced in the presence of poly(cis-1,4-isoprene). In contrast, oxiB and oxiA, which are located directly downstream of lcp and putatively encode a heteromultimeric aldehyde dehydrogenase oxidizing the primary cleavage products generated by Lcp from poly(cis-1,4-isoprene), were expressed only in the presence of poly(cis-1,4-isoprene). Expression of lcp at a low level is thus required for sensing the polymer in the medium. Rubber degradation products may then induce the transcription of genes coding for enzymes catalyzing the later steps of poly(cis-1,4-isoprene) degradation and the transcription of lcp itself. lcp, oxiB, and oxiA seem to constitute an operon, as a polycistronic mRNA comprising these three genes was detected. The transcriptional start site of lcp was mapped 400 bp upstream of the lcp start codon.