材料科学
介电谱
钝化
胶凝的
腐蚀
石墨烯
涂层
拉曼光谱
氧化物
化学工程
氯化物
电化学
水泥
透射电子显微镜
扫描电子显微镜
铬酸盐转化膜
复合材料
极化(电化学)
冶金
色散(光学)
无机化学
环氧树脂
阴极保护
作者
Olajide Tunmilayo Sanya,Daman K. Panesar
标识
DOI:10.1016/j.cemconcomp.2026.106851
摘要
Uniform dispersion of graphene oxide (GO) within epoxy coatings is essential for improving the corrosion resistance of steel rods in alkaline cementitious environments exposed to chloride. This study examines the influence of GO content (wt.%) on the coating resistance of GO/epoxy-coated steel in simulated pore solutions representative of General Use Limestone (GUL) and General Use (GU) cements. Simulated solutions were prepared from ionic compositions of expressed pore solutions obtained from GUL and GU cement pastes with and without 5 wt.% NaCl. Chloride exposure increased Na + , Cl - , and SO 4 2- concentrations and reduced OH - , with GUL exhibiting slightly higher sulfate and conductivity. GO was characterized using Fourier-transform infrared spectroscopy (FTIR), Raman spectroscopy, X-ray diffraction (XRD), transmission electron microscopy (TEM), and atomic force microscopy (AFM). Neat epoxy and GO/epoxy coatings containing 0.1, 0.3, 0.5, and 1.0 wt.% GO were synthesized, and their electrochemical properties were evaluated using open-circuit potential (OCP), electrochemical impedance spectroscopy (EIS), and linear polarization resistance (LPR) in simulated GUL and GU pore solutions containing 5 wt.% NaCl after a 14-day passivation stage. For both GUL and GU simulated pore solutions containing 5 wt.% NaCl, the 0.5 wt.% GO/epoxy coating exhibited the most stable OCP, highest low-frequency impedance, and lowest corrosion current densities. This indicates that adding 0.5 wt.% GO significantly enhances long-term corrosion resistance of epoxy-coated steel in simulated GUL and GU pore solutions.
科研通智能强力驱动
Strongly Powered by AbleSci AI