In this thesis, we focus on emerging model bimetallic systems (Pt-M/Al2O3), in which low amounts of platinum are dispersed within nanoparticles of inexpensive, non-noble promoters (M NPs). These systems have been reported as highly efficient for the propane dehydrogenation (PDH) reaction.Our objective is to systematically explore, under identical test conditions, the influence of both the Pt loading (below 0.3 wt.%) and the nature of the promoter metal (Cu, Sn or Ga) on PDH performance. These catalytic behaviours are further correlated with changes in the local environment of Pt atoms. To this end, intricate control over the formation of Pt-M entities on the Al2O3 support was pursued through experimental design of simplified chemical methods.The first part of the manuscript addresses the challenging synthesis of sub-10 nm non-noble metal nanoparticles (Cu0, Sn0, or Ga0) that exhibit inherent resistance to oxidation. A generic chemical reduction route was developed, involving the use of a mild, environmentally friendly reducing agent (L-ascorbic acid) in ethylene glycol. Notably, efficient reduction was achieved at a relatively low temperature (80 °C), despite continuous exposure to oxygen and humidity.To enable effective deposition of these preformed colloidal nanoparticles onto the Al₂O₃ support, their surface charge behaviour was investigated via ζ-potential measurements as a function of pH. This allowed us to design an optimized pH-controlled loading strategy, yielding M/Al2O3 parent materials. Platinum was then introduced in a controlled manner via galvanic replacement, leading to the formation of well-defined Pt-M/Al2O3 catalysts.Finally, catalytic testing enabled the identification of the optimal Pt-M composition with respect to the two key variables studied (Pt loading and promoter choice) that govern enhanced PDH performance.