甲脒
钙钛矿(结构)
铯
钝化
能量转换效率
材料科学
丙烷
化学
无机化学
光电子学
纳米技术
结晶学
图层(电子)
有机化学
作者
Xiuwen Xu,Yue‐Min Xie,Yuhui Ma,Menglin Li,Chunqing Ma,Chun‐Sing Lee,Sai‐Wing Tsang
出处
期刊:Solar RRL
[Wiley]
日期:2019-05-16
卷期号:3 (8)
被引量:20
标识
DOI:10.1002/solr.201900140
摘要
Incorporating diammonium cations, which electrostatically connect the adjacent inorganic slabs ([PbI6]4−), into 3D perovskite is recently proposed to develop high‐performance perovskite solar cells (PSCs). However, due to limited studies, the effects of these organic cations on the perovskite structural and optoelectronic properties are yet to be understood. Herein, a diammonium cation, propane‐1,3‐diammonium (PDA), is first proposed to modulate the cesium–formamidinium (Cs–FA)‐mixed cation perovskite. By increasing the PDA content, the efficiency of the Cs0.15FA0.85 − xPDAxPbI3 PSC first increases and then drastically decreases. The highest power conversion efficiency (PCE) of 18.10% obtained by Cs0.15FA0.83PDA0.02PbI3 is superior to that of the Cs0.15FA0.85PbI3 (16.82%). Through systematic investigations, it is revealed that the PDA content–dependent efficiency is attributed to a competition between the enhanced defect passivation and emerged excitonic effect with an increased PDA content. Moreover, the encapsulated Cs0.15FA0.83PDA0.02PbI3 device exhibits almost 1.5 times increased stability than the Cs0.15FA0.85PbI3 counterpart, with 83% of its initial efficiency retained after 500 h exposure, under continuous light soaking at 60 °C in ambient air. This study provides a practical strategy to enhance the device stability without sacrificing the efficiency and deepens our understanding on effects of diammonium cation incorporated in 3D perovskite.
科研通智能强力驱动
Strongly Powered by AbleSci AI