材料科学
磨料
磨损(机械)
复合材料
偷看
聚合物
复合数
摩擦学
涂层
热固性聚合物
风化土
分层(地质)
胶粘剂
金属
冶金
古生物学
物理
天体生物学
生物
构造学
图层(电子)
俯冲
作者
Kian Bashandeh,Pixiang Lan,Andreas A. Polycarpou
出处
期刊:Wear
[Elsevier BV]
日期:2022-07-31
卷期号:506-507: 204461-204461
被引量:25
标识
DOI:10.1016/j.wear.2022.204461
摘要
Abrasive wear of polyether ether ketone (PEEK) and aromatic thermosetting co-polyester (ATSP) based polymer composite coatings were examined with lunar regolith simulant environment by conducting pin-on-disk experiments under dry sliding conditions, contact pressure of 17.5 MPa, and sliding speed of 0.25 m/s. Three different tribo-interfaces, namely metal-on-metal, metal-on-polymer, and polymer-on-polymer were designed to evaluate the efficacy of each polymer coating on the friction and wear improvement, as well as the extent of sand-dust mitigation at the interface. The polymer-on-polymer system resulted in significant reduction in friction up to 70%. The wear mechanism was a mixed mode of two-body and three-body abrasion for metal-on-metal and metal-on-polymer tribopairs, while the polymer-on-polymer tribopair significantly mitigated the sand and dust accumulation at the interface with three-body abrasion as the dominant wear. Both polymer composites showed similar frictional behavior, while ATSP composite showed superior abrasive wear resistance, particularly under small size dust (<38 μm size) environment. • Polymer coatings as an efficient method to reduce the COF and sand-dust mitigation. • ATSP coating showed higher resistance to abrasive wear compared with PEEK. • Continuous reduction of COF and wear by coating deposition on both pin and disk. • Metal-on-polymer sliding showed two-body abrasive wear as dominant wear mechanism. • Polymer-on-polymer sliding showed three-body abrasive wear as dominant mechanism.
科研通智能强力驱动
Strongly Powered by AbleSci AI