材料科学
环氧化物
糠醛
有机化学
环氧树脂
呋喃
阳离子聚合
固化(化学)
化学工程
化学
催化作用
高分子化学
复合材料
工程类
作者
Jin Ku Cho,Jae‐Soung Lee,Jaewon Jeong,Bora Kim,Baekjin Kim,Sangyong Kim,Seunghan Shin,Hyun‐Joong Kim,Sang‐Hyeup Lee
标识
DOI:10.1080/01694243.2012.697700
摘要
Current issues of energy and environment prompt us to replace fossil-based resources with renewable and sustainable ones. In this regard, carbohydrate biomass photosynthesized from atmospheric carbon dioxide attracts much attention due to its abundance and availability. Recently, furanic compounds that can be derived from carbohydrate biomass are highlighted as promising substitutes for aromatic compounds that are totally dependent on petroleum reforming processes. In this article, we report on several carbohydrate biomass-based furanic compounds as alternatives to petroleum-based adhesives. Furanic compounds bearing epoxide end group(s) were synthesized from renewable and sustainable carbohydrate biomass-based compounds (>70% yields). Another bis-epoxy furanic compound with a mimetic structure of bisphenol A (BPA) was also synthesized from xylose-derived 2-furan carboxylic acid and acetone (39% overall yield). In particular, epoxy groups were efficiently introduced to the hydroxymethyl functionality attached by furanic cores under the bi-phasic solvent system using phase transfer catalysis. Cationic photo-curing kinetic profiles of synthetic compounds were investigated in terms of heat flow integrals using photo-DSC. It was found that their halftime values (t 1/2), representing curing rates, ranged from 0.54 to 1.15 min when irradiated with 40 mW/cm2 UV light. When synthetic furanic compounds functionalized by epoxide group(s) were used for bonding polycarbonate by cationic photo-curing, we noted that tensile-shear strength of PC joints bonded with biomass-based furan mono-epoxide having furan ring was greater (4.7 MPa) than that of joints bonded with petrochemical-based phenyl glycidyl ether having phenyl ring (2.6 MPa). When bonded with di-epoxide functionalized furan di-epoxide, tensile-shear strength of PC joint was 3.5 MPa after photo-curing for 3 min at 40 °C. However, bis-furan di-epoxide (bFdE), the mimetic compound of BPA showed lower tensile-shear strength (approximately 1 MPa) due to structural features of bFdE, such as rigidity and hydrophobic property.
科研通智能强力驱动
Strongly Powered by AbleSci AI