The Influence of Polymer Impregnating Materials on Structural Strengthening of 3D Printed Sand Molds Produced by Binder Jetting Method

Additive manufacturing offers great potential for various industrial solutions; in particular, the binder jetting method enables the production of components from various materials, including sand molds for casting. This work presents the results of an extensive set of experiments aimed at enhancing the structural strengthening of 3D-printed sand molds. Structural strengthening was achieved by impregnating the sand-printed structures with two polymer materials: epoxy resin and silicone varnish. Impregnation was performed with variable parameters, such as temperature, pressure, and time. Structural strengthening using polymers was investigated by analyzing the flexural strength and impact resistance of the impregnated products and comparing these obtained values with the reference material in terms of impregnation parameters and the polymer used. Microstructural observations and an analysis of the pore filling were also performed. This approach allowed for a full assessment of the influence of processing parameters and the type of polymer used for impregnation on the properties of sand-printed structures, which allowed for identifying the most optimal method to be used to strengthen the sand molds for casting the components for electrical devices. As a direct proof of concept, it was shown that impregnation with polymeric materials could effectively strengthen the sand mold, increasing its flexural strength and impact resistance by over 20 times and 5 times, respectively. A full-scale mold was printed using binder jetting, impregnated with epoxy resin at 65 °C, and used to successfully fabricate a fully functional electrification device.