结构工程
弯曲
管(容器)
章节(排版)
工程类
剪接
极限抗拉强度
条状物
封面(代数)
材料科学
横截面(物理)
纯弯曲
复合材料
电缆密封套
焊接
螺栓连接
变形(气象学)
实验研究
有限元法
单调函数
失效模式及影响分析
作者
Rajarshi Das,Dan Dragan,Hervé Degée
出处
期刊:ce/papers
[Wiley]
日期:2026-09-01
卷期号:9 (2-3): 1640-1645
摘要
Abstract Circular Hollow Section (CHS) columns are widely used in modern construction due to their high resistance to axial, tensile, and bending loads in all directions, as well as their architectural appeal. However, conventional end plate ‐ bolted splice connections often reduce structural efficiency by concentrating damage in the bolts and are frequently considered visually intrusive. To address these drawbacks, the EU‐RFCS project LASTTS developed an innovative laser‐cut “passing‐through” concept that enhances both the structural performance and the aesthetics of a splice connection. This study examines three configurations: (1) CS‐1, where CHS columns are connected using fully inserted passing‐through steel plates, bolts, and steel cover plates positioned outside the tube diameter; (2) CS‐2, using partially inserted passing‐through steel plates, bolts, and steel cover plates placed inside the tube diameter; and (3) CS‐3, featuring partially inserted passing‐through steel plates, bolts, and steel end plates located inside the tube diameter. An experimental program comprising full‐scale specimens is carried out at the ACB2 laboratory of UHasselt under monotonic tensile and four‐point monotonic bending loads. This paper presents the specimen design, test setup, instrumentation, force–displacement behavior, moment‐rotation response, and strain development, while comparing the structural behavior of the three configurations based on the experimental results.
科研通智能强力驱动
Strongly Powered by AbleSci AI