Microstructure simulation and experimental evaluation of the anisotropy of 316 L stainless steel manufactured by laser powder bed fusion

Purpose The effect of processing parameters on the microstructure of steel produced by laser-based powder bed fusion (LPBF) is a recognized opportunity for property design through microstructure control. Because the LPBF generates a textured microstructure associated with high anisotropy, it is of interest to determine the fabrication plane that would generate the desired property distribution within a component. Design/methodology/approach The microstructure of 316 L produced by LPBF was characterized experimentally (optical, scanning electron microscopy, glow discharge emission spectrometry and X-ray diffraction), and a finite element method was used to study the microstructure features of grain diameter, grain orientation and thermal parameters of cooling rate, thermal gradient and molten pool dimensions. Findings The computational tool of Ansys Additive was found efficient in reproducing the experimental effect of varying laser power, scanning speed and hatch spacing on the microstructure. In particular, the conditions for obtaining maximum densification and minimum fusion defects were consistent with the experiment, and the features of higher microhardness near the component’s surface and distribution of surface roughness were also reproduced. Originality/value To the best of the author’s knowledge, this paper is believed to be the first systematic attempt to use Ansys Additive to investigate the anisotropy of the 316 L SS produced by LPBF.