SCAPS Numerical Analysis of Graphene Oxide /TiO2 Bulk Heterojunction Solar Cell Sensitized byN719 Ruthenium Dye

Solid-state dye-sensitized solar cells (SSDSC) have been fabricated using two different metal oxide materials, graphene oxide and titanium oxide, are used as hole and electron transport materials, respectively. The N719 dye ruthenium between the hole and electron transport materials to act as an absorber layer in your Go/N719dye/TiO2 solar cells. Through the SCAPS-1D simulation, it was found that the Go/N719dye/TiO2 solar cells have significantly improved the performance of the solar cells compared to the Go/TiO2 solar cells. Specifically, the short circuit current (Jsc) has increased from 0.17 mA/cm2 to 1 mA/cm2, the open circuit voltage (Voc) has increased from 0.2 V to 1 V, and the power conversion efficiency (η) has increased from 0.02% to 2.5%. Additionally, Various factors that can affect the performance of Go/N719 dye/TiO2 solar cells. It was found that the optimal dye thickness for achieving high short circuit current density, high power conversion efficiency, and high open circuit voltage is between 200nm and 300nm. Furthermore, the operating temperature of the solar cells also affects their performance. Increasing the operating temperature negatively affects the open circuit voltage and power conversion efficiency of the cells, while the short circuit current density is slightly enhanced. Finally, the efficiency of a solar cell can be affected by the type of metal used for the electrode and the type of semiconductor material used in the cell. In Ni and Cu electrodes solar cells ohmic contacts allow for efficient transfer of electrons, whereas Schottky barriers can impede electron flow and reduce efficiency in Mo and Ag electrodes solar cells .