热解
聚丙烯
催化作用
差示扫描量热法
化学工程
材料科学
热重分析
焦炭
分解
热分解
有机化学
废物管理
化学
复合材料
冶金
工程类
物理
热力学
作者
Linh T. T. Nguyen,Gérrard Eddy Jai Poinern,Hanh T.N. Le,Nguyễn Anh Tiến,Chien M. Tran,Zhong‐Tao Jiang
摘要
Abstract The pyrolysis and catalytic reforming process of waste plastics are the best pathways to handle vast amounts of waste plastics as they can convert these waste polymers into sustainable products. This study aims to incorporate a natural‐clay‐mineral (NCM) with LaFeO 3 nanoparticles, with the LaFeO 3 /NCM catalyst in the pyrolysis of polypropylene (PP) being used as an example of plastic waste. The decomposition of PP with and without catalyst has been theoretically studied using thermogravimetry (TG) and differential scanning calorimetry (DSC) measurements under atmospheric pressure and nitrogen atmosphere. The TG/DSC results show that (i) the required temperature for pyrolysis of PP with or without catalyst in a practical system ranges from 460°C to 480°C; (ii) the amount of coke produced on the surface of the NCM or LaFeO 3 is about 2 wt.% compared with the initial plastic levels; (iii) with the catalyst, PP not only goes through the phase transitions of solid to liquid to gas but also decomposition and combination processes between components from the hydrocarbon chain scission of PP. Gas chromatography–mass spectrometry (GC–MS) results show significant differences in the fuel oil recovered from the pyrolysis and catalytic reforming process. In the presence of the catalyst, cracking components consist of 49.3% alkenes (branched‐chain alkenes, cyclo‐alkenes, and alkenes) and 34.4% alkanes, while without the catalyst, branched‐chain alkenes were up to 90.2%. Repeated pyrolysis and GC–MS investigations demonstrated the reusability of the LaFeO 3 /NCM catalyst, which is promising for its recycling and the efficient pyrolysis of PP.
科研通智能强力驱动
Strongly Powered by AbleSci AI