Microstructural Organization and Mechanical Properties of 5356 Aluminum Alloy Wire Arc Additive Manufacturing Under Low Heat Input Conditions

This study examines the microstructure and mechanical properties of 5356 aluminum alloy under low heat input conditions during arc additive manufacturing, focusing on the challenges posed by excessive heat input, which hinders specimen formation and affects dimensional accuracy. The study analyzes the characteristics of single-pass multilayer straight-walled specimens fabricated under varying low heat input conditions, along with evaluations of their mechanical properties, including their microstructure, microhardness, and tensile strength. This study demonstrates that as the heat input increases from 87.5 J/mm to 190.0 J/mm, the width of the vertical wall specimens increases significantly, whereas the change in single-layer height remains minimal. The specimen width increases from 5.22 mm to 8.87 mm, representing a change of 3.65 mm, while the single-layer height increases by only 0.16 mm. The microstructure primarily consists of the α(Al) matrix and the skeletal β(Al3Mg2) phase. As heat input increases, some of the β(Al3Mg2) phase dissolves, resulting in a decrease in its distribution density, a reduction in its quantity, and an increase in its size. The average hardness increases from 69.40 HV at 87.5 J/mm to 77.89 HV at 154.2 J/mm, before decreasing to 73.56 HV at 190.0 J/mm. As the heat input increases, the tensile strength and elongation of both horizontal and vertical specimens initially increase and then decrease. The tensile strength and elongation of the horizontal specimens are slightly greater than those of the vertical specimens. The microstructure and mechanical properties vary across different regions. In the upper region, the β(Al3Mg2) phase is uniformly distributed, with high density and small size. The fracture surface exhibits fine, uniform dimples, displaying the best microhardness and mechanical properties, with a tensile strength of 245.88 MPa. In the middle region, the distribution density of the β phase decreases, the size increases, and the dimples become slightly coarser. Consequently, the microhardness and mechanical properties decline. At the bottom, due to the higher cooling rates, the β phase does not dissolve significantly. The distribution density is high, the dimples are large and uneven, and the microhardness and mechanical properties are the lowest, with a tensile strength of 236.00 MPa.