Cryogenic H-Bridge Converter for HTS Degaussing Application

<p>A degaussing system can be used to reduce the detectability of the magnetic signature of a ship. Commonly, a degaussing system consists of a set of onboard copper coils that produce a magnetic field to compensate for the magnetic signature. High-temperature superconductive degaussing coils are considered an alternative to copper degaussing coils because of a reduction in energy losses, weight, volume, and costs. The losses of a high-temperature superconductor (HTS) degaussing system can be reduced even further by powering it with a cryocooled converter with parallel mosfets. A low-duty cycle and smaller current leads can be used. These solutions eliminate most of the power source losses. This article investigates such a cryocooled converter. The effect of the low switching frequency on the converter performance is tested. A prototype that can operate at cryogenic temperatures was built. The converter powers an HTS coil. It was found that a load current of 50 A can be achieved with a duty cycle of just 0.025 at an input voltage of 3.5 V while still meeting the requirement of a maximum current ripple of 0.5%. At a switching frequency higher than 100 Hz, the converter's performance deteriorates. Also, oscillations were observed in the circuit. This is a problem due to the low blocking voltage of the mosfets. The parasitic inductances in the circuit have a high impact on the performance because the resistance in the circuit is very low.</p>