电阻器
分压器
微控制器
电阻式触摸屏
过采样
电气工程
电压
电子工程
计算机科学
分流器
工程类
电压基准
分频器
RC电路
功率(物理)
电度表
电压降
接口(物质)
观测误差
标识
DOI:10.1109/jsen.2025.3644007
摘要
The paper presents a new low-power interface circuit based on a voltage divider consisting of a reference resistor, a resistive sensor and a microcontroller equipped with an ADC. The novelty of the solution is that the input of the voltage divider and the reference input of the ADC are connected to the same output pin of the microcontroller, making the voltage divider only be stimulated during measurements, which significantly reduces the power consumption, and the resistance measurements of the sensor independent of the supply voltage and the on-resistance of the microcontroller pin, which reduces the measurement error. The method was illustrated based on a widely used Arduino module and resistors with values corresponding to a Pt1000 sensor. The paper also proposes a software systematic error correction algorithm used for circuit calibration, which reduces the relative systematic errors to the level of the quantisation error of a 10-bit ADC (0.2%). An oversampling method was also used and tested. Experimental studies show that 64-fold oversampling can reduce the relative random error to 0.06%.
科研通智能强力驱动
Strongly Powered by AbleSci AI