光引发剂
材料科学
生物相容性
光致聚合物
水溶液
光刻胶
乙二醇
聚合
化学工程
单体
纳米技术
聚合物
复合材料
有机化学
化学
冶金
工程类
图层(电子)
作者
Yongchao Zheng,Yuanyuan Zhao,Mei‐Ling Zheng,Shi‐Lu Chen,Jie Liu,Feng Jin,Xian‐Zi Dong,Zhen-Sheng Zhao,Xuan‐Ming Duan
标识
DOI:10.1021/acsami.8b15011
摘要
We have introduced a novel water-soluble two-photon photoinitiator based on the host-guest interaction between 3,6-bis[2-(1-methyl-pyridinium)vinyl]-9-pentyl-carbazole diiodide (BMVPC) and cucurbit[7]uril (CB7) because most of the commercial photoinitiators have poor two-photon initiating efficiency in aqueous solutions. The binding ratio of BMVPC and CB7 was determined as 1:1 by isothermal titration calorimetry and quantum chemical calculation. The formation of the host-guest complex increases the two-photon absorption cross-section about five times, and improves the water solubility required as the photoinitiator for hydrogel fabrication. The BMVPC-CB7 inclusion complex was used as the one-component photoinitiator, and the polyethylene glycol diacrylate with promising biocompatibility was used as the hydrogel monomer to form the aqueous-phase photoresist system applied to two-photon polymerization microfabrication. A relatively low laser threshold of 4.5 mW, a high fabricating resolution of 180 nm, and the true three-dimensional (3D) fabricating capability in the aqueous solution have been obtained by using the as-prepared photoresist system. Finally, 3D engineering hydrogel scaffold microstructures with low toxicity and good biocompatibility have been fabricated and cocultured with living HeLa cells, which demonstrates the potential for further application in tissue engineering.
科研通智能强力驱动
Strongly Powered by AbleSci AI