电极
双层
过电位
电解质
材料科学
图层(电子)
光电子学
化学
分析化学(期刊)
氧化物
电流密度
钠
集电器
钒
电池(电)
锰
参比电极
活动层
无机化学
电化学
作者
Galen L.V. Brown,Stanislaw Piotr Zankowski,Patrick S. Grant
标识
DOI:10.1149/1945-7111/ae482c
摘要
We present a novel bilayer architecture of a Na-ion positive electrode consisting of two sub-layers of different active materials: sodium manganese oxide (Na 0.7 MnO 2+ x , NMO) and sodium vanadium phosphate ( Na 3 V 2 ( PO 4 ) 3 , NVP). The bilayer electrodes are 100 μm thick with high areal loading of ≈17 mg cm −2 . For low current densities (<1 C ≡ 45.5 mAg −1 cm −2 ) relative electrode charging capacity was not affected by bilayering, while at higher C-rates the overall charging capacity became sensitive to the relative position of NMO and NVP sub-layers. An optimum configuration of an NMO layer between the current collector and an NVP layer (CC/NMO/NVP) significantly increased overall electrode capacity during fast charging, with capacity retention ∼30% higher than the other configurations at 3C (136 mAg −1 cm −2 ). The sensitivity of electrode performance to sub-layer position was attributed to the differing voltage-capacity profiles of NMO and NVP, combined with a decrease in overpotential likely due to a reduction in through-thickness Na-ion electrolyte concentration gradients. The faster charging CC/NMO/NVP arrangement showed no significant detriment in discharge behavior, and overall the electrode discharge responses were less sensitive to the spatial arrangement of active materials.
科研通智能强力驱动
Strongly Powered by AbleSci AI