计算机科学
能量(信号处理)
网络数据包
功率(物理)
电子工程
数据传输
无线
电气工程
工程类
能量转移
传输(电信)
无线电源传输
传输(计算)
实时计算
高效能源利用
计算机网络
时分复用
频率响应
钥匙(锁)
无线传感器网络
能量交换
作者
Xinyu Hou,Shuaikang Wang,Yuheng Zhang
标识
DOI:10.1109/tte.2026.3737960
摘要
To address selective energy allocation in heterogeneous master-slave automated guided vehicle (AGV) systems, this paper proposes a single-inverter dual-frequency wireless power transfer (WPT) system that combines topology-induced frequency splitting with energy-packet time-division multiplexing (TDM). In the proposed system, two operating frequencies are selected according to the topology-dependent frequency characteristics, including topology-induced frequency splitting, and are used for hardware-level frequency addressing of the corresponding energy-transfer paths. Heterogeneous band-stop filters are further employed to provide frequency-selective channel separation. A variable dead-time packet-header protection strategy is further introduced to improve the commutation margin during rapid frequency transitions. An experimental prototype was built to verify the proposed method. The experimental operating frequencies were 197.6 kHz and 227.3 kHz, and the load resistance was varied from 60 Ω to 150 Ω. In the single-target charging mode, the output current of the Master AGV remained within 0.745–0.800 A, with a peak output power of 83.28 W and a peak DC–DC efficiency of 82.97%; the output current of the Slave AGV remained within 0.800–0.830 A, with a peak output power of 99.24 W and a peak DC–DC efficiency of 93.20%. Under dual-frequency energy-packet operation, the system achieved adjustable power allocation between the two AGV channels, with a peak output power of 60.03 W and a peak DC–DC efficiency of 81.74%. These results verify the feasibility of the proposed dual-frequency energy-packet WPT system for selective and load-independent power delivery in laboratory-scale masters-lave AGV charging scenarios.
科研通智能强力驱动
Strongly Powered by AbleSci AI