摩尔质量
降级(电信)
工业化学
摩尔比
化学
臼齿
摩尔质量分布
分布(数学)
制浆造纸工业
复合材料
材料科学
聚合物
有机化学
数学
生化工程
催化作用
生物
计算机科学
工程类
古生物学
数学分析
电信
作者
Etienne Montet,Dominique Lachenal,Christine Chirat
标识
DOI:10.1515/npprj-2024-0082
摘要
Industrial oxygen-delignified and fully-bleached hardwood kraft pulps were treated with chemicals to provoke carbohydrates depolymerisation: ozone, hypochlorous acid, and cellulase. The degrees of polymerisation (DP) of cellulose obtained by pulp viscosity measurement in Cuen and by size-exclusion chromatography after direct dissolution in DMAc/LiCl indicated the extent of the chemical degradation inflicted to the fibres. Molar mass distributions (MMD) described the carbohydrates depolymerisation patterns. Fibre strength was assessed by measuring the zero-span tensile index at never-dried state. Fibre strength deterioration seemed to be mainly driven by the topochemistry of the cellulose degradation (homogeneous or localised), rather than by its intensity usually measured as an average DP loss. In fact, depolymerisation by cellulase was found critically detrimental to fibres strength whereas ozone and hypochlorous acid induced little harm to the fibres despite a significant cellulose depolymerisation. According to these results, in line with several past studies, fibre strength measurements should be performed systematically as the sole pulp viscosity is an inadequate indicator. Alternatively, albeit being insufficient strength predictors on their own MMD can give valuable insight on the topochemistry of the cellulose degradation, a key aspect when monitoring fibre strength preservation during pulping and bleaching.
科研通智能强力驱动
Strongly Powered by AbleSci AI