材料科学
离子电导率
快离子导体
多孔性
电解质
无定形固体
离子键合
电导率
化学工程
固溶体
电化学
复合材料
分析化学(期刊)
扫描电子显微镜
晶格常数
复合数
电阻率和电导率
多孔介质
电化学窗口
衍射
吸收(声学)
断层摄影术
电化学电位
作者
Oskar Thompson,Ove Korjus,Adrien Fauchier‐Magnan,Clément Albin,Sergio Federico Mayer,Emmanuelle Suard,Thomas C. Hansen,Laura Henry,Nicolas Guignot,Vittoria Pischedda,Sylvie Le Floch,Claire Villevieille
摘要
ABSTRACT Proper densification of thiophosphate solid electrolytes is crucial for enhancing ionic transport and for preventing dendrite formation and ensuring mechanical stability. However, achieving optimal densification remains challenging due to the absence of techniques capable of monitoring structural and morphological changes in real time. We design a specific airtight high‐pressure cell and clamp, enabling the in situ investigation of amorphous (Li 3 PS 4 ) and crystalline (Li 6 PS 5 Cl) sulfide‐based solid electrolytes. Using X‐ray computed tomography and diffraction at the Psiché beamline (SOLEIL synchrotron), we studied the samples under uniaxial compression up to 3700 MPa. We correlate the evolution of structure, density, and porosity with ionic conductivity measurements obtained via electrochemical impedance spectroscopy. The results reveal two densification stages: an initial closure of intergranular porosity, followed by structural densification through elimination of intragranular porosity. The porosity in Li 3 PS 4 reduces faster than in Li 6 PS 5 Cl, reflecting its higher softness. Above 500 MPa, ionic conductivity decreases, likely due to lattice contraction and increased Li + migration barriers. Upon decompression, both materials exhibit irreversible conductivity enhancement, attributed to plastic densification and increased structural disorder. These findings highlight the critical role of microstructural control and pressing conditions in optimizing the electrochemical performance of sulfide‐based solid electrolytes.
科研通智能强力驱动
Strongly Powered by AbleSci AI