The Analysis of Influence of Compression Forces on the Strength of MM „Stahl 1018” Composite with the use of SolidWorks

Composite Multimetal Stahl 1018 has been used in the process of preserving worn surfaces of materials operating in extremely difficult conditions. This work presents the results of simulation of the mechanical properties of steel samples in contact with the MM "Stahl 1018" composite. Tests were carried out for various models with with one- and two-sided contact sample models with the composite. Theoretical tests were conducted in the "SolidWorks 2019" environment. It was found that the maximum strength of the specimen layer made of MM "Stahl 1018" material, which closely adheres to the surfaces of steel bases on both sides (444 MPa) is higher than that of the material layer in one-sided contact (358 MPa), for specimens with a height of 4.5 mm and at 80 °C. Simulations also revealed a significant increase in the maximum stress in the composite MM "Stahl 1018" for specimens in the so-called free state from 285 MPa to 358 MPa with the increasing temperature from 20 °C to 80 °C, for specimens 4.5 mm high.