Co‐, Ni‐, and Cu‐Doped Fe‐Based Catalysts for the Microwave‐Assisted Catalytic Pyrolysis of Polyethylene

Abstract Environmental issues caused by waste polyethylene are becoming increasingly severe. Among potential treatment processes, microwave‐assisted catalytic pyrolysis is promising for converting waste plastics into valuable products owing to its energy efficiency and environmental sustainability. Herein, a modified citric acid combustion method was used to prepare a series of metal oxide catalysts with loose porous structures. The prepared Fe‐based catalysts doped with Co, Ni, or Cu were employed in the microwave‐assisted catalytic pyrolysis of polyethylene. The bimetallic Co 1 Fe 1 O x catalyst exhibited the best performance, yielding hydrogen at a rate of 60.7 mmol/g plastic . Further variation in the Co : Fe ratio revealed that the Co 1 Fe 9 O x catalyst achieved the highest hydrogen production efficiency (63.64 mmol/g plastic ). Similar oil‐phase products were obtained over the various catalysts, as revealed by infrared spectroscopy and proton nuclear magnetic resonance spectroscopy. Furthermore, scanning electron microscopy (SEM) identified carbon nanotubes as the major solid product of pyrolysis, which were attached to the catalyst surface. Finally, a combination of thermogravimetric analysis, SEM, and energy‐dispersive X‐ray spectroscopy indicated that the reduction in catalytic activity following recycling was caused by the accumulation of carbonaceous products on the catalyst surface. Overall, Co 1 Fe 9 O x catalysts were favorable for obtaining H 2 and carbon nanotubes by the microwave‐assisted pyrolysis of polyethylene.