A New Design and Embedded Implementation of a Low‐Cost Maximum Power Point Tracking Charge Controller for Stand‐Alone Photovoltaic Systems

This article presents a low‐cost maximum power point tracking (MPPT) charge controller designed to efficiently charge solar batteries using a simple and robust MPPT method, while providing protection against over‐currents and over‐voltages. The proposed MPPT approach utilizes a modified Incremental Conductance (INC) algorithm adapted to low‐cost embedded controllers, as it avoids all the mathematical division calculations typically used in the conventional INC algorithm. It also introduces a modified step size based only on photovoltaic (PV) power change to enhance tracking accuracy and convergence speed. Furthermore, to reduce the stress and switching losses of DC–DC converter, a feedback control with two proportional and integral (PI) compensators is also used to control both the PV voltage and to protect the battery from over‐currents using PV power limitation technique. Simulation results, carried out under MATLAB/Simulink, demonstrate the good performance of the proposed control scheme regarding any variations in atmospheric conditions, both for the MPPT control and for the battery charge control. Finally, a processor‐in‐the‐loop (PIL) test using a low‐cost Arduino MKR ZERO board is also performed to verify the hardware implementation of the proposed method. PIL results are in totally accordance with MATLAB/Simulink simulation results, which further proves the effectiveness of the proposed method.