材料科学
极限抗拉强度
复合材料
多孔性
饱和(图论)
聚乳酸
抗压强度
模数
发泡剂
弹性模量
超临界流体
延伸率
聚合物
化学
有机化学
组合数学
数学
作者
Jinwei Chen,Libin Yang,Dahua Chen,Mai Qunshan,Meigui Wang,Wu Lixuan,Ping Kong
标识
DOI:10.1177/0262489320930328
摘要
Microcellular polylactic acid (PLA) foams with various cell size and cell morphologies were prepared using supercritical carbon dioxide (sc-CO 2 ) solid-state foaming to investigate the relationship between the cell structure and mechanical properties. Constrained foaming was used and a wide range of cell structures with a constant porosity of ∼75% by tuning saturation pressure (8–24 MPa) was developed. Experiments varying the saturation pressure while holding other variables’ constant show that the mean cell size and the mean cell wall thickness decreased, while the cell density and the open porosity increased with increase of pressure. Tensile modulus of PLA foams decreased with increasing the saturation pressure, but the specific tensile modulus of PLA foams was still 15–80% higher than that of solid PLA. Tensile strength and elongation at break first increased with increasing saturation pressure up to 16 MPa and then decreased with further increasing saturation pressure (20 MPa and 24 MPa) at which opened-cell structure produced. Compressive modulus, compressive strength, and compressive yield stress also followed the same variation trend. The results indicated that not only cell size plays an important role in properties of PLA foams but also cell morphology can influence these properties significantly.
科研通智能强力驱动
Strongly Powered by AbleSci AI