Effect of an intermolecular disulfide bond introduced into the first loop of CH1 domain of Adalimumab Fab on thermal stability and antigen-binding activity

The introduction of intermolecular disulfide bonds by amino acid mutations is an effective method for stabilizing dimeric proteins. X-ray crystal structure of Fab of a therapeutic antibody, adalimumab, revealed the first loop of the CH1 domain to be partially unsolved at position 135-141. To find new sites for the introduction of intermolecular disulfide bonds in adalimumab Fab, Fab mutants targeting the unsolved region were predicted using molecular simulation software. Four Fab mutants, H:K137C-L:I117C, H:K137C-L:F209C, H:S138C-L:F116C and H:S140C-L:S114C, were expressed in the methylotrophic yeast Pichia pastoris. SDS-PAGE analysis of these mutants indicated that H:K137C-L:F209C, H:S138C-L:F116C and H:S140C-L:S114C mutants mostly formed intermolecular disulfide bonds, whereas some H:K137C-L:I117C mutants formed intermolecular disulfide bonds and some did not. Differential scanning calorimetry measurements showed increased thermal stability in all Fab mutants with engineered disulfide bonds. The bio-layer interferometry measurements, for binding of the antigen tumor necrotic factor α, indicated that Fab mutants had less antigen-binding activity than wild-type Fab. In particular, the KD value of H:K137C-L:F209C was ~17 times higher than that of wild-type Fab. Thus, we successfully introduced intermolecular disulfide bonds between the first loop region of the CH1 and CL domains and observed that it increases the thermostability of Fab and affects the antigen-binding activity.