Preparation of porous superabsorbent particles based on starch by supercritical CO2 drying and its water absorption mechanism

The slow water-absorption speed of starch-based superabsorbent resin (St-SAP) limits its application. In this study, porous St-SAP (P-St-SAP) was prepared by inverse suspension polymerization and supercritical CO2 drying, the aim is to provide a preparation method of fast absorbent resin. The P-St-SAP at 33 % starch content had an interpenetrating porous structure with macropores, mesopores and micropores, and the surface area, pore volume and average pore diameter were 32.06 m2·g−1, 0.116 cm3·g−1 and 21.6 nm, respectively. The water-absorption process included rapid-section, medium-section and slow-section, according with internal diffusion, double-constant and quasi second-order kinetic models, respectively. In the initial 30 s, a water-absorption speed of 262.6 g·g−1·min−1 in distilled water was much higher than some previous research results, and the equilibrium absorption value of 517.9 g·g−1 in distilled water and 72.9 g·g−1 in 0.9 % saline was better than that of non-porous St-SAP at similar starch content. Moreover, at the same stage the percentage of saline absorption ratio to equilibrium absorption value was 1.0– 2.0 times higher than that of distilled water. These research results indicate that the P-St-SAP has fast water-absorption speed and good salt resistance, which will have greater application prospects in sanitary materials, building concrete pouring, and flood control blocking piping.