电磁屏蔽
材料科学
复合材料
芳纶
铜
电阻率和电导率
电阻抗
电气工程
冶金
纤维
工程类
作者
Lothar O. Hoeft,Edward W. Tokarsky
出处
期刊:
[Institute of Electrical and Electronics Engineers]
日期:2002-11-07
卷期号:2: 883-886
被引量:12
标识
DOI:10.1109/isemc.2000.874739
摘要
The electromagnetic shielding characteristics of four fabric samples made from metal clad aramid yarn and nickel plated copper wire were measured from 1 kHz to 3 GHz. Below 100 kHz, these measurements showed that the surface transfer impedance or surface resistivity ranged from 0.5 m/spl Omega//square to 1.3 m/spl Omega//square. This is extremely good. In this frequency range, the current flows on the wires. Between 10 and 100 MHz, the mid-frequency or limiting shielding effectiveness was greater than 70 dB. At 100 MHz and above, all samples were essentially equal at 45 m/spl Omega//square. In this frequency range the current spreads across the fabric. A diffusion cut-off frequency was not observed in any of the samples.
科研通智能强力驱动
Strongly Powered by AbleSci AI