Precise recognition and efficient recovery of Pd(II) from high-level liquid waste by a novel aminothiazole-functionalized silica-based adsorbent

Efficient recognition, separation and recovery of palladium from high-level liquid waste (HLLW) not only helps the safe, green and environmentally friendly disposal of nuclear waste, but also is an essential important supplement to overcome the growing shortage of natural palladium resources. Herein, a novel silica-based functional adsorbent named 2AT-SiAaC was prepared by a two-step method, i.e., grafting of 2-aminothiazole (2AT) via the amidated reaction after in-situ polymerization of acrylic monomers on porous silica. SEM, EDS, TG-DSC, BET and PXRD all proved the successful preparation of 2AT-SiAaC, and it exhibited ultrahigh adsorption selectivity for Pd(II) (Kd (distribution coefficient) ≥ 10,344.2 mL/g, SFPd/M (separation factor) ≥ 613.7), fast adsorption kinetics with short equilibrium time (t ≤ 1 h) and good adsorption capacity (Q ≥ 62.1 mg Pd/g). The dynamic column experiments shows that 2AT-SiAaC achieved efficiently separation of Pd(II) from simulated HLLW, and the enrichment coefficients (C/C0) of Pd(II) was as high as about 14 with the recovery rate nearly 99.9% and basically kept the same performance in three adsorption-desorption column cycle experiments. The adsorption mechanism was analyzed by FT-IR, XPS and DFT calculations, and the ultrahigh selectivity of 2AT-SiAaC was attributed to the preferred affinity of the soft N-donor atoms in 2AT for Pd(II). NO3- ions participated in the adsorption reaction to keep charge balance, and the frontier orbital electron density distribution diagram shows the charge transfer in the process of material preparation and adsorption. To sum up, 2AT-SiAaC adsorbent provided a new insight for precise recognition and efficient separation of Pd(II) from HLLW.