Tribology of Mg-B4C nanocomposites fabricated following powder metallurgy route

Abstract In this experimental work, magnesium nanocomposite reinforced with various percentage of boron carbide (0.5%, 1.0%, 1.5%, 2.0% by volume) is fabricated using conventional powder metallurgy technique. Characterisation and wear test of the fabricated composite have been performed using scanning electron microscopy, tribology test monitor respectively. It is observed that addition of B4C increases the hardness and wear resistance linearly. Addition of 2% B4C produces the hardness of the nanocomposites as high as 57.93±4.9 Hv. Furthermore, the nanocomposites displayed improved wear resistance and lower friction coefficient compared to the base magnesium. The influence of sliding speed on these properties has been systematically presented. The paper provides an in-depth exploration of wear mechanisms through a meticulous analysis of SEM micrographs of worn surfaces. This work offers valuable insights into the microstructural characteristics and tribological behaviour of Mg-B4C nanocomposites. These findings underscore the potential application of Mg-B4C nanocomposites in the development of lightweight wear-resistant materials. The impact of incorporating minute amounts of nano-sized boron carbide into Mg, on its behaviour under small loads and repeated scratching has been investigated in this study. Moreover, introspection of the wear mechanisms and the effectiveness of the powder metallurgy technique in fabricating composite materials is presented.