A study of airborne wear particles from automotive disc brakes

During braking, both the disc and pads in disc brakes are worn. Since disc brakes are not sealed,some of the wear particles generated can become airborne. Several studies have found anassociation between adverse health effects and the concentration of particles in the atmosphere,so it is of interest to improve our knowledge of the airborne wear particles generated by discbrakes. This thesis deals with experimental and computational methods focusing on airborne wearparticles from disc brakes. The eight appended papers discuss the possibility to both measure andnumerically determine the concentration and size distribution of airborne wear particles thatoriginate from the pad-to-disc contact. The objective is to increase the scientific knowledge ofairborne wear particles generated from disc brakes. Papers A, B and C describe tests of disc brake materials conducted in a modified pin-on-discmachine. The results show that the test set-up can be used to measure and rank disc brakematerials with respect to the concentration of airborne particles generated. Ultrafine (nanosized),fine and coarse airborne wear particles that contain metals such as iron, copper and tin werefound. Papers D and E describe a novel disc brake assembly test stand and tests of disc brake materialsconducted in it. The results show that the test set-up can be used to measure the concentrationand size distribution of airborne wear particles generated from disc brake materials. The resultsalso indicate an ability to rank different pad/disc combinations with respect to the concentrationof airborne wear particles. Furthermore, the results suggest that this test stand can be used tostudy rust layer removal from the disc and that airborne particles are generated even at low brakepressures, such as used to remove dirt from the disc. Paper F compares measurements made in passenger car field tests with measurements made in adisc brake assembly test stand and in a pin-on-disc machine. A promising correlation between thethree different test methods is found. Paper G presents and discusses a simulation methodology that numerically determines theconcentration and size distribution of airborne wear particles generated from the pad-to-disccontact in disc brakes by using general-purpose finite element software. Paper H discusses a cellular automaton model that describes the microscopic contact situationbetween the pad and disc in disc brakes. This model is used to numerically determine the amountof wear that leaves the contact. The results correlate qualitatively with experimental observationsfound in the literature.