冯·米塞斯屈服准则
材料科学
有限元法
牙冠(牙科)
斜格
植入
压力(语言学)
结构工程
口腔正畸科
复合材料
工程类
外科
哲学
医学
语言学
作者
João Paulo Mendes Tribst,Niek de Jager,Amanda Maria de Oliveira Dal Piva,Cornelis J. Kleverlaan,Albert Joseph Feilzer
出处
期刊:Heliyon
[Elsevier BV]
日期:2024-03-01
卷期号:10 (6): e28129-e28129
被引量:9
标识
DOI:10.1016/j.heliyon.2024.e28129
摘要
This study aimed to investigate the effect of four retention systems for implant-supported posterior crowns under compressive loading using three-dimensional finite element analysis. A morse-taper dental implant (4.1 × 10 mm) was designed with Computer Aided Design software based on non-uniform rational B-spline surfaces. According to International Organization for Standardization 14,801:2016, the implant was positioned at 3 mm above the crestal level. Then four models were designed with different crown retention systems: screw-retained (A), cement-retained (B), lateral-screw-retained (C), and modified lateral-screw-retained (D). The models were imported to the analysis software and mesh was generated based on the coincident nodes between the juxtaposed lines. For the boundary conditions, two loads (600 N) were applied (axial to the implant fixture and oblique at 30°) totaling 8 conditions according to retention design and loading. The von-Mises stress analysis showed that different retention systems modify the stress magnitude in the implant-supported posterior crown. There is a similar stress pattern in the implant threads. However, models C and D presented higher stress concentrations in the crown margin in comparison with A and B. The oblique loading highly increased the stress magnitude for all models. In the simulated conditions, part of the stress was concentrated at the lateral screw under axial loading for model C and oblique loading for model D. The results indicate a possible new failure origin for crown retained using lateral screws in comparison to conventional cement-retained or screw-retained systems.
科研通智能强力驱动
Strongly Powered by AbleSci AI