P‐6.11: Optimizing AMOLED Product Data Programming via eDP Interface

This paper studies how to implement Flash data programming for AMOLED display module products through eDP interface. eDP interface is an internal digital interface based on DisplayPort architecture and protocol, which has the advantages of high transmission rate and low power consumption, but is not suitable for transmitting non‐image or video data. Therefore, AMOLED display modules usually need additional interfaces to write key data (such as Demura, Gamma and TCON firmware) into Flash chips, which brings some problems of data transmission interference, unreliability and inefficiency. To solve these problems, this paper proposes a new operation method, which repackages the data to be written, converts them into images, sends them to TCON through eDP interface, and then TCON analyzes the images, extracts the valid data, and starts programming for Flash. This paper divides the whole process into three steps, and verifies the feasibility and effectiveness of the method through experiments. This method effectively solves the problem of data programming, simplifies the production process, and improves the speed and reliability of programming.