The EPA's sliding-scale emission-removal requirement is encouraging the use of nonregenerable, dry-scrubbing systems for flue gas desulfurization. The advantages of dry scrubbing over wet scrubbing include an easier-to-handle dry waste, no wet/dry interfaces to cause scaling and plugging, no need for corrosion-resistant construction materials, minimum maintenance because operation is at low material volumes and low pressures, 50-75Vertical Bar3< lower energy requirements, and much lower water consumption. However, the dry-scrubbing systems are economical only at low sulfur dioxide concentrations in the flue gas due to the use of sorbents more expensive than limestone. The first commercial unit in the U.S. went on stream in July 1979 at a Strathmore Paper Co. pulp mill; four more projects will be completed within three years. Firms developing spray-dryer systems include Carborundum Co., Joy Manufacturing Co., Niro Atomizer Inc., and a Rockwell International Corp./Wheelabrator-Frye Inc. joint venture. Dry-injection systems are under study at Carborundum and Energy and Pollution Controls Inc.