Synthesis of High Performance Si Nanoflakes and Nanorod Anode Morphologies Using Water Soluble Recyclable Templates for Lithium Ion Batteries

材料科学 阳极 硅 纳米棒 纳米技术 锂(药物) 模板 纳米结构 化学气相沉积 化学工程 光电子学 电极 化学 物理化学 内分泌学 工程类 医学
作者
Bharat Gattu,Pavithra Murugavel Shanthi,Moni Kanchan Datta,Prashanth Jampani,Prashant Nagesh Kumta
出处
期刊:Meeting abstracts [Institute of Physics]
卷期号:MA2016-01 (1): 51-51
标识
DOI:10.1149/ma2016-01/1/51
摘要

Silicon based anode systems have attracted considerable attention as alternative materials to replace graphite as a high energy density anode for lithium ion batteries due to silicon’s high theoretical capacity (~4200mAh/g). However, the material suffers from colossal volumetric expansion (~400%) associated with the formation of Li4.4Si phase during the lithiation reaction. Over the past few years, different approaches have been developed to address this issue which causes mechanical degradation and results in rapid loss in capacity of silicon anodes. These approaches involve the use of silicon nanoparticles [1], composite structures of amorphous silicon [2], active-inactive matrices [3], electrodeposited thin films and VACNT-Si heterostructures [4-6]. Nanostructures of silicon have been shown to withstand the mechanical pulverization by providing stress – strain relaxation mechanisms thus, showing improved cycling stability. However, most of the synthesis methods used to generate these Si nanostructures involve high processing costs, complex machinery/equipment, utilization of expensive templates and large number of processing steps. Additionally these materials show higher first cycle irreversible (FIR) loss and have poor areal loading densities. In the present work, Si nanostructures are generated using a simple two-step procedure employing a low-cost recyclable template. The template was generated using a high throughput high energy mechanical milling process (HEMM) utilizing an abundant, cheap and water soluble material. Si nanoflakes and Si nanorods (deposited using low pressure chemical vapor deposition) were obtained by varying the template synthesis conditions. The template is then recovered and reused by washing in water making the procedure amenable for commercialization. Slurry based electrodes of these nanostructures mixed with binder and conductive additives were then fabricated and tested in a half cell configuration against lithium foil between the voltage range 0.01V – 1V vs. Li/Li+ in 1M LiPF6(dissolved in EC:DEC:FEC=45:45:10) electrolyte. Fig. 1a shows the XRD patterns of the two different morphologies of silicon obtained using this simple two-step procedure. It can be seen therein that the procedure can be tailored to obtain either amorphous (Si flakes) or nanocrystalline (Si rods) silicon materials. The aim of this study is to understand the effect of the synthesis conditions on the morphology, crystal structure and subsequent electrochemical performance of low-cost template-derived silicon nanostructures. It can be seen in Fig. 1b that both morphology and crystallinity affect the silicon capacity and cycling behavior of both silicon morphologies. Though Si rods show a superior first cycle discharge capacity (~2790 mAh/g at current rate of 50mA/g; FIR loss ~12%-13%) as compared to Si flakes (~2930 mAh/g at current rate of 50mA/g; FIR loss ~17%-20%), the long term cycling behavior is in stark contrast, with Si nanoflakes and nanorods showing a fade rate of ~0.03% and ~0.4% loss per cycle, respectively, due to the differences in morphology and crystallinity. Additionally, electrodes with areal loading density of ~1.3 – 1.5mg/cm2were obtained independent of the morphology of the silicon nanostructures. Furthermore, Si nanoflakes and nanorods showed a specific discharge capacity of ~1150mAh/g and ~1025mAh/g, respectively (at a current rate of 1A/g), at the end of 150 cycles. Results of these studies will be presented and discussed. Acknowledgement: The authors gratefully acknowledge financial support of DOE contract administered through PNNL and NSF-CBET 1511390. The authors also acknowledge the Edward R. Weidlein Chair Professorship funds and the Center for Complex Engineered Multifunctional Materials (CCEMM) for support of this research. References: [1] I. Kim, P.N. Kumta, G.E. Blomgren, Electrochemical and Solid State Letters 3 (2000) 493-496. [2] X.H. Liu, L. Zhong, S. Huang, S.X. Mao, T. Zhu, J.Y. Huang, Acs Nano 6 (2012) 1522-1531. [3] M.K. Datta, J. Maranchi, S.J. Chung, R. Epur, K. Kadakia, P. Jampani, P.N. Kumta, Electrochimica Acta 56 (2011) 4717-4723. [4] W. Wang, R. Epur, P.N. Kumta, Electrochemistry Communications 13 (2011) 429-432. [5] W. Wang, P.N. Kumta, Acs Nano 4 (2010) 2233-2241. [6] R. Epur, M.K. Datta, P.N. Kumta, Electrochimica Acta 85 (2012) 680-684. Figure 1

科研通智能强力驱动
Strongly Powered by AbleSci AI
科研通是完全免费的文献互助平台,具备全网最快的应助速度,最高的求助完成率。 对每一个文献求助,科研通都将尽心尽力,给求助人一个满意的交代。
实时播报
初初初啊发布了新的文献求助10
1秒前
希望天下0贩的0的应助被yy采纳,获得10
1秒前
wanci的应助被哈哈哈采纳,获得10
2秒前
上岸发布了新的文献求助10
3秒前
3秒前
彭于晏的应助被wei采纳,获得10
4秒前
window1000发布了新的文献求助10
4秒前
dit发布了新的文献求助10
4秒前
碗四完成签到 ,获得积分10
5秒前
5秒前
6秒前
6秒前
阿茶完成签到,获得积分20
7秒前
7秒前
8秒前
8秒前
8秒前
8R60d8的应助被清辉影采纳,获得10
8秒前
9秒前
9秒前
Aria完成签到,获得积分10
9秒前
Superman发布了新的文献求助10
10秒前
霓虹我哄完成签到,获得积分10
10秒前
10秒前
Ming发布了新的文献求助10
11秒前
儒雅一凤发布了新的文献求助10
11秒前
科研小李发布了新的文献求助200
11秒前
初初初啊发布了新的文献求助10
11秒前
fanxiare发布了新的文献求助10
12秒前
今后的应助被是小周采纳,获得10
12秒前
renn发布了新的文献求助30
12秒前
水天需发布了新的文献求助10
13秒前
13秒前
华仔的应助被别急采纳,获得10
13秒前
英俊的铭的应助被正直的夏青采纳,获得30
14秒前
14秒前
王彬完成签到,获得积分10
15秒前
15秒前
小二郎的应助被廖喜林采纳,获得10
15秒前
XU发布了新的文献求助10
15秒前
高分求助中
(应助此贴封号)【重要!!请各用户(尤其是新用户)详细阅读】【科研通的精品贴汇总】 10000
拉伸高分子熔体中缠结行为的模拟和小角中子散射研究 1700
The World Atlas of Wine 9th edition 1000
奈特基础组织学:配套组织病理学(第4版)(Netter's Essential Histology With Correlated Histopathology) 800
八旗制度の研究 600
Improving the wear resistance of vehicle gear oil by oil soluble LaF3 nanoparticles and typical additives of gear oil 500
Boundaries and Bodhisattvas 500
热门求助领域 (近24小时)
化学 材料科学 医学 生物 纳米技术 计算机科学 工程类 有机化学 化学工程 生物化学 物理 复合材料 内科学 催化作用 光电子学 人工智能 细胞生物学 无机化学 物理化学 数学
热门帖子
关注 科研通微信公众号,转发送积分 8183923
求助须知:如何正确求助?哪些是违规求助? 9573132
关于积分的说明 21829461
捐赠科研通 7781024
什么是DOI,文献DOI怎么找? 3434150
关于科研通互助平台的介绍 2558333
邀请新用户注册赠送积分活动 2480648