Study on Creep Damage in Sn60Pb40 and Sn3.8Ag0.7Cu (Lead-Free) Solders in c-Si Solar PV Cell Interconnections under In-Situ Thermal Cycling in Ghana

A numerical study on the creep damage in soldered interconnects in c-Si solar photovoltaic cells has been conducted using equivalent creep strain, accumulated creep strain and accumulated creep energy density methods. The study used data from outdoor weathering of photovoltaic (PV) modules over a three-year period (2012–2014) to produce temperature cycle profiles that served as thermal loads and boundary conditions for the investigation of the soldered interconnects’ thermo-mechanical response when exposed to real-world conditions. A test region average (TRA) temperature cycle determined in a previous study for the 2012–2014 data was also used. The appropriate constitutive models of constituent materials forming a typical solar cell were utilized to generate accurate material responses to evaluate the damage from the thermal cycles. This study modeled two forms of soldered interconnections: Sn60Pb40 (SnPb) and Sn3.8Ag0.7Cu (Pb-free). The results of the damage analysis of the interconnections generated from the thermal cycle loads using accumulated creep strain method showed that the Pb-free solder interconnection recorded greater damage than that of the SnPb-solder interconnection for the TRA, 2012, 2013 and 2014 temperature cycles. The percentage changes from SnPb to Pb-free were 57.96%, 43.61%, 44.87% and 45.43%, respectively. This shows significant damage to the Pb-free solder under the TRA conditions. Results from the accumulated creep energy density (ACED) method showed a percentage change of 71.4% (from 1.3573 × 105 J/mm3 to 2.3275 × 105 J/mm3) in accumulated creep energy density by replacing SnPb-solder with Pb-free solder interconnection during the TRA thermal cycle. At the KNUST test site in Kumasi, Ghana, the findings show that Sn60Pb40 solder interconnections are likely to be more reliable than Pb-free solder interconnections. The systematic technique employed in this study would be useful to the thermo-mechanical reliability research community. The study also provides useful information to PV design and manufacturing engineers for the design of robust PV modules.