Exploiting interfacial polymerization to fabricate hyper-cross-linked nanofiltration membrane with a constituent linear aliphatic amine for freshwater production

Abstract Humanity is facing a global challenge of dwindling water resources and the situation is intensifying due to growing population leading to excessive water pollution. Nanofiltration is an important membrane-based technology for the production of clean and potable water for domestic and industrial setups. Hyper-cross-linked polyamide thin film composite nanofiltration (HCPA-TFC-NF) membranes have been fabricated by using multifunctional amine 1 (possessing two primary -NH2 and two secondary -NH groups) and bifunctional terephthaloyl chloride 2 (TPC) through interfacial polymerization. The structure of the hyper-cross-linked polyamide network has been successfully confirmed by solid (CP-MAS) 13C NMR, XPS, AFM, FT-IR, elemental mapping, and EDX analysis. The membrane features such as surface morphology and hydrophilicity have been established by FE-SEM and water contact angle measurements. The FE-SEM analysis revealed the formation of uniform polyamide active layer on the surface of PS/PET support, and the pore structure of the membranes was tuned by studying the effect of curing temperature and curing time. The nanofiltration membranes efficiently rejected a series of divalent salts including MgCl2, CaCl2, Na2SO4, MgSO4, and NaCl using cross-flow filtration setup. Based on the cross-flow filtration performance, the best conditions for the membrane fabrication were found to be curing temperature of 80 °C with a curing time of 1 h. The highest salt rejection was observed in case of MgCl2 reaching to a value of 98.11% in case of HCPA-TFC-NF@M3 and it was found to be 97.45% in case of HCPA-TFC-NF@M2 while the rejection of MgCl2 was reduced to 94.59% in case HCPA-TFC-NF@M1. HCPA-TFC-NF@M2 showed NaCl rejection of 87.36%. The hydrofluoric acid treatment of HCPA-TFC-NF-M2 increased the water flux while keeping the rejection high. The HCPA-TFC-NF@M2 showed a rejection of >99% for EBT with a permeate flux of 75 LMH.