Bifunctional low molecular weight polyacrylic acid as aqueous binder and coating agent enables high performance LiMn2O4 cathode for lithium-ion batteries

LiMn2O4 is considered to be a promising cathode material for lithium-ion batteries due to its decent energy density, low price and environmental benignity. However, the problems of Mn dissolution, migration and deposition during the cycle, seriously affect its lifespan, especially at high temperature. In this study, we developed a strategy by which we killed two birds with one stone. A low molecular weight polyacrylic acid (PAA) mixed with sodium carboxymethyl cellulose (CMC) is applied as binder and coating agent for cathode particles at the same time. The conventional and environmental unfriendly polyvinylidene difluoride (PVDF)-N-methylpyrrolidone (NMP) system is replaced by the cheap and green aqueous binder with improved adhesive effect. Furthermore, the binder-based surface coating layer not only alleviates the side reaction between the electrolyte and the cathode particles, but also chelates the dissolved Mn2+ by the large amount of carboxyl groups in PAA molecules and so prevents the following migration and deposition of Mn2+. In the button half-cell with low molecular weight PAA based binder, the capacity retention reaches 94.1 % after 1000 cycles at room temperature and 92.0 % after 200 cycles at 60 degrees centigrade. Meanwhile, 18650-type cylindrical cells were prepared with this binder, which shows a great high temperature storage performance. After the cell was held at 60 degrees centigrade for 25 days at full charged state, the internal resistance increased by only 1.25mΩ, the voltage decreased by only 0.1 V, the residual capacity retention and recovery capacity retention reaches 85.6 % and 92.2 %. This work shows the great potential of the aqueous binder in dealing with the problem of Mn dissolution during the cycling of manganese-based cathode materials for lithium-ion batteries.