Influence of diamond-like carbon coatings and micro-texturing on friction and wear of seal interfaces: Experiment and simulation study

For mechanical seal friction vice in dry friction conditions, due to friction wear serious failure, is the slurry pump and other instruments in the operation of the process of the urgent need to solve the problem. In this paper, in order to optimize and enhance the friction and wear problem of mechanical seal end face of slurry pump. Surface treatment of mechanical sealing rings with diamond-like carbon (DLC) coating and surface microtexturing, and at different rotational speeds and normal forces, the surface hardness, wear coefficient and dry friction coefficient of the sealing rings were analyzed by experimental comparison, and the wear morphology was collected by electron microscopy, having analyzed the results of the sets of, the end face structure of the mechanical seal was optimized. Based on Archard wear model simulation calculations, the seal ring wear depth and wear quality were obtained. The results show: under dry friction conditions, the synergistic effect of the DLC coating and the surface micro-texture (MT), the coefficient of friction is reduced by approx. 68% and the quality and depth of wear is minimized. Excessive speeds and normal forces are more prone to wear behavior caused by abrasive wear. Simulation results of surface treatment groups, DLC / MT group maximum wear depth is the smallest; wear quality test and simulation of the maximum error within 15.7%. The results of the study can provide a basis for a phosphoric acid plant slurry pump mechanical seal design.