Design of an Automobile Injection Mould Based on Automation Technology

At present, there are frequent occurrences in the industry of manufacturers only having products, but they have no product data, resulting in manufacturers unable to open molds to produce the products themselves and can only buy them at high prices. This article takes the rear case of an automobile generator produced by a company as an example, which aims to show the design of automobile injection molds through automation technology. This paper studies the use of automation technology to achieve the automatic model reconstruction of products, and uses the CAD technology to design injection molds based on the obtained digital models of products. This paper also uses the CAE technology to verify the feasibility and rationality of the designed mold, exploring the optimization method of the injection molding process of the mold. In this paper, a special product pouring system and demolding mechanism are designed according to the product process requirements. The design greatly simplifies the mold structure while fulfilling the product process requirements, which avoids the use of expensive hot runners and complex flip-chip mold structures, reducing the mold manufacturing cost. Secondly, the overall design of the injection mold is carried out, and the external dimensions and other main parameters of the mold are determined. Then, Moldflow software is used to simulate the injection molding process, verifying the feasibility and rationality of the designed mold. The optimization method of the injection molding process is also proposed, and the optimal injection process parameters are determined to ensure that the mold can produce qualified products and ensure high production efficiency. It can be seen from the analysis results that the maximum warpage deformation of the plastic part under all effects is 0.65 mm, which meets the product process requirements.