Tribological properties of HFCVD diamond coatings over wide temperature range

Single and gradient multilayered diamond coatings, deposited on silicon nitride (Si 3 N 4 ), were prepared by hot filament chemical vapour deposition. The tribological properties were evaluated in a wide temperature range (26 °C–300 °C), against Si 3 N 4 ceramic balls, as the friction counterpart. The results showed that with the increase of temperature from 26 °C to 300 °C, the wear rate of NCD (nanocrystalline diamond) and GCD (gradient diamond) coatings rapidly increases. When the temperature reaches 300 °C, obvious cracks and detachment appear on the surface of the NCD coatings. Due to the special interlayer, the wear rate of the GCD coatings is lower than that of the NCD coatings. In the range of 26 °C to 100 °C, GCD exhibits excellent wear resistance and low friction coefficient due to its special gradient structure. When the temperature increases to 200 °C, NCD films with smaller grain sizes exhibit higher wear rates. From the wear morphology, it can be seen that cracks are generated in the NCD film, and as the temperature increases, the cracks continue to expand until the film spalling. GCD shows relatively good wear resistance at high temperatures. This study found that gradient multilayered diamond coatings exhibited superior wear resistance at high temperatures, compared with single-layer coatings tested in identical conditions.