校准
电阻器
电容感应
电极
失真(音乐)
材料科学
采样(信号处理)
等效串联电阻
观测误差
时间常数
混叠
审问
电子工程
分析化学(期刊)
光电子学
常量(计算机编程)
准确度和精密度
计算机科学
欧姆
电阻抗
声学
电阻温度计
化学
微电极
信号(编程语言)
电气工程
灵敏度(控制系统)
吸收(声学)
参比电极
航程(航空)
作者
Jennifer M. Gibson,Julian O. Gerson,Kon Son,Tod E. Kippin,Kevin W. Plaxco,Lior Sepunaru,Bob M. Lansdorp
出处
期刊:ACS Sensors
[American Chemical Society]
日期:2026-11-11
标识
DOI:10.1021/acssensors.6c03721
摘要
By providing continuous, in vivo molecular measurements, electrochemical aptamer-based (EAB) sensors have the potential to improve the fidelity with which pharmaceutical drugs are administered and physiological processes are monitored. The impact of solution resistance on EAB sensor response, however, has not been systematically investigated, despite its potential to introduce systematic errors in concentration measurements. Here, we show that uncompensated solution resistance of wire-based EAB sensors can increase from a few hundred ohms in vitro up to ∼1-2 kΩ in vivo. This elevated resistance increases the RC charging time constant of the electrode interface, allowing non-faradaic charging currents to persist into the sampling window used during square wave voltammetry. As a result, capacitive currents contribute to the measured signal, distorting sensor responses whenever the interrogation frequency falls within this RC-limited charging regime. Using three representative EAB sensors, we show that changes in uncompensated solution resistance between calibration and measurement conditions can, for some sensors, cause target concentrations to be systematically underestimated, with the magnitude of this error strongly dependent on interrogation frequency. We also introduce a simple strategy by which the calibration of in vivo EAB sensors can be improved by introducing a resistor in series with the working electrode during in vitro testing. Finally, we provide further strategies by which the errors introduced by uncompensated solution resistance can be reduced to negligible levels.
科研通智能强力驱动
Strongly Powered by AbleSci AI