作者
Wei Dai,Yaoke Wen,Zhouyu Shen,Haoran Xu,Weixiao Nie,Yang Yu,Yongxian Zhu
摘要
Abstract This study focuses on TPU-LW, a commercial 3D-printed foamed thermoplastic polyurethane (TPU) material produced by eSUN, aiming to explore its feasibility as a customized knee pad liner for impact energy absorption. To determine the optimal printing temperature and structural parameters of the BCCH knee pad liner, a research method combining material experiments and structural optimization was adopted. First, quasi-static tensile, compression, and hardness tests were conducted on foamed TPU samples printed at temperatures of 220, 230, 240, 250, and 260°C. After comprehensively considering material hardness and mechanical properties, the printing temperature for the BCCH structure was determined to be 250°C. Subsequently, 80 sets of parameter combinations for 4 structural parameters (i.e., planar beam width H1, planar beam width W1, diagonal beam width H2, and diagonal beam height W2) were designed via Latin hypercube sampling (LHS), and the training dataset for the prediction model was obtained through quasi-static compression experiments. The prediction model, based on a neural network improved with residual blocks, realizes the prediction of structural mass, energy absorption, and specific energy absorption. Meanwhile, with the aid of the NSGA-II multi-objective optimization algorithm, a Pareto optimal solution set maximizing both specific energy absorption and energy absorption was obtained. Finally, the optimal structural parameters were selected as follows: H1 = 1.62, W1 = 1.2, H2 = 2, and W2 = 1.96 mm. The knee pad liner was fabricated via 3D printing, and a bionic knee joint target was prepared based on SEBS gel and a medical joint teaching model for drop ball impact tests. The test results indicate that the BCCH liner can effectively reduce the peak force borne by the bionic patella during impact: without protective gear, the maximum force on the patellar surface under bare-leg impact reaches 6.47 N; when only wearing the hard knee pad shell, the maximum force decreases to 1.447 N; while after wearing the knee pad equipped with the BCCH liner, the maximum force on the patellar surface drops to 0.823 N, with a maximum force reduction rate of approximately 87.28%. This confirms the effectiveness of the BCCH liner in impact protection. This study opens up a new technical approach for the design of customized personal protective equipment.