Experimental investigation of the sectional buckling of built-up cold-formed steel columns

This paper presents an experimental program investigating the local and/or distortional (sectional) buckling of built-up cold-formed steel sections subjected to pure compression. The experiments were designed to study the influence of key parameters, including buckling mode, cross-section geometry and fastener spacing, on the ultimate sectional capacity of built-up columns. Three singly- or doubly-symmetric built-up sections were considered with two sets of component lipped channel sections, one buckling predominantly in the distortional mode and one buckling in the local mode. The component sections were connected using self-drilling screws at three different spacings. Material properties, geometric imperfections and residual stresses of the specimens were measured prior to testing. A total of 36 specimens with a length of 1 m were tested under concentric compression between fixed ends, which was achieved through a special end plate connection. The specimens failed in either distortional or the interaction of local and distortional buckling modes. Compared to the sum of the capacity of component sections, the ultimate capacity in built-up columns with distortional buckling mode increased significantly with the reduction of screw spacing, whereas the increase was minor for specimens that failed through local-distortional interaction. The ultimate strength of the specimens was predicted using the current Direct Strength Method, where either conservative or overly unconservative predictions were obtained depending on the considered composite action level in the elastic buckling analysis.