Experimental study of shielding gas concentration on mechanical properties of stainless steel alloy parts using wire and arc additive manufacturing

Wire Arc Additive Manufacturing (WAAM) is an emerging three-dimensional fabrication technology that enables higher deposition rate, material savings, and near net-shape. In this study, various shielding gas concentration (SGC) of argon (Ar) and carbon-di-oxide (CO 2 ) was employed to fabricate 316L using Cold Metal Transfer (CMT) WAAM process. Microstructure characteristics and mechanical properties of thick-walled parts were studied. Microstructure studies show a combination of columnar and equiaxed grains in various regions. Microhardness results exhibit the uneven distribution of hardness value from bottom to top region along the building direction and the values are ranging between185 and 240 HV. Tensile studies indicates the both horizontal and vertical direction samples secures the higher ultimate tensile strength (UTS), yield strength (YS) and elongation (EL) values and confirmed the isotropic properties. Fractography studies prove ductile fracture with the evidence of dimples and enough plastic deformation. From the experimental results, the SGC-2 possesses finer solidification structure and higher mechanical properties than the other samples. The as-fabricated WAAM parts possess higher mechanical properties than the 316L parts fabricated via casting and wrought parts.