Surface-wetting characterization using contact-angle measurements

Wetting, the process of water interacting with a surface, is critical in our everyday lives and in many biological and technological systems. The contact angle is the angle at the interface where water, air and solid meet, and its value is a measure of how likely the surface is to be wetted by the water. Low contact-angle values demonstrate a tendency of the water to spread and adhere to the surface, whereas high contact-angle values show the surface’s tendency to repel water. The most common method for surface-wetting characterization is sessile-drop goniometry, due to its simplicity. The method determines the contact angle from the shape of the droplet and can be applied to a wide variety of materials, from biological surfaces to polymers, metals, ceramics, minerals and so on. The apparent simplicity of the method is misleading, however, and obtaining meaningful results requires minimization of random and systematic errors. This article provides a protocol for performing reliable and reproducible measurements of the advancing contact angle (ACA) and the receding contact angle (RCA) by slowly increasing and reducing the volume of a probe drop, respectively. One pair of ACA and RCA measurements takes ~15–20 min to complete, whereas the whole protocol with repeat measurements may take ~1–2 h. This protocol focuses on using water as a probe liquid, and advice is given on how it can be modified for the use of other probe liquids. The wettability of a surface can be determined by measurement of the contact angle between a water droplet and the surface. This protocol describes sessile-drop goniometry for the measurement of advancing and receding contact angles.