In this work, synthesis and characterization of an anode supported tubular solid oxide fuel cell based on Ba 0.5 Sr 0.5 Ce 0.6 Zr 0.2 Gd 0.1 Y 0.1 O 3-δ (BSCZGY) electrolyte has been investigated. Anode-supported Ni - yttria-stabilized zirconia (YSZ) anode was fabricated via slip casting; BSCZGY electrolyte and BSCZGY - La 0.6 Sr 0.4 Co 0.2 Fe 0.8 O 3 (LSCF) composite cathode were coated on support using dip coating, respectively. The chemical compatibility of fuel cell components at sintering temperatures has been investigated by powder X-ray diffraction, and no severe reactions were detected. Electrochemical examination under air/H 2 + 3 vol. % H 2 O showed superior performance achieving a maximum power density of 1 W/cm 2 at 850°C, among the best compared to tubular – geometry oxygen conductor solid oxide fuel cells reported earlier and one of the highest reported for a proton conductor electrolyte in literature. Electrochemical impedance spectroscopy was used to examine the electrochemical performance of the full cell at different temperatures, and a detailed analysis was done to distinguish the contribution of ohmic and polarization resistances of the cell. ASR values were 3.47 Ω.cm 2 , 1.81 Ω.cm 2 , 1.23 Ω.cm 2 , and 1.05 Ω.cm 2 at 600, 700, 800, and 850°C, respectively. Analysis of activation energy associated with charge and mass transfer based on fitting of impedances revealed that concentration polarization is the major contributor to the total resistance. The long-term stability for more than 96 hours of operation under load showed no significant degradation, which demonstrated the steady behavior of the cell.