Effect of Sc contents on the mechanical properties and damping capacity of Al–Zn–Mg–Cu–Zr–Sc alloys with different grain structures

Al-Zn-Mg-Cu-Zr-Sc alloys with different Sc contents were fabricated by casting, deformation, and T6 treatment. Deformation methods including rolling and friction-stir processing (FSP) were used to design their grain structure. A low additive amount (0.1) of Sc cannot refine the grains of the alloy with rolling and T6 treatment, and it instead coarsened the grains. The reason was the non-uniform distribution of nanosize Al₃(Sc,Zr) phases that led to the occurrence of abnormal grain growth during homogenization. Meanwhile, the alloy with only 0.1Sc exhibited finer grains after FSP and T6 treatment than the alloys subjected to the same process but with higher Sc additive amount. Alloys with rolling-induced elongated grain structure exhibited better mechanical properties, and alloys with FSP-induced fine equiaxed grain structure exhibited higher high-strain and high-temperature internal friction values. These features are important performance parameters for applications in fields where vibration and noise are sensitive. The optimum additive amounts of Sc for alloys with elongated and fine equiaxed grain structures were 0.25 and 0.1, respectively.