High Energy Density Li-Ion Batteries with Atomic-Level Multi-Functional Modified LiCoO2 Cathode

作者
Weibing Xing
出处
期刊:Meeting abstracts [Institute of Physics]
卷期号:MA2017-02 (1): 73-73
标识
DOI:10.1149/ma2017-02/1/73
摘要

Transition metal oxides are commonly used as cathode materials for state-of-the-art (SOA) Li-ion batteries. Owing to possessing a redox potential of ~ 4V (vs. Li/Li+), they are usually referred as 4V cathode materials. Among them, LiCoO2 (LCO) has been the most frequently used in commercial Li-ion batteries [1]. LCO has a layered structure with hexagonal symmetry where lithium ion (Li+) can reversibly be extracted via two-dimensional pathways [2]. The highly oxidizing Co4+/3+ redox couple provides a cell voltage of ~ 4V vs. Li/Li+. Although LCO has a theoretical specific capacity of 270 mAh/g, corresponding to x = 0 in LixCoO2 or ~ 5V vs. Li/Li+, only 50% of the LCO theoretical capacity can be practically achieved in commercial Li-ion cells, i.e. x » 0.5 in LixCoO2, corresponding to ~140 mAh/g or ~ 4.2V vs. Li/Li+. This is because further Li+ extraction or delithiation from pristine LCO, corresponding to x < 0.5 in LixCoO2 or > 4.2V vs. Li/Li+, will lead to a: (i) large concentration of Co4+ ions that are unstable (Co4+ dissolution) and (ii) large change in lattice parameter c accompanied by phase transitions that cause structure degradation [3]. In addition, conventional carbonate solvent-based Li-ion electrolytes are unstable (oxidative decomposition) when operating at high voltages, e.g., > 4.6V vs. Li/Li+. These factors can lead to accelerated battery capacity fade when attempting to gain more capacity (e.g., > 140 mAh/g) from pristine (unstabilized) LCO. Here we present a novel approach to develop a high voltage, high energy density LCO (HV-LCO) with robust cycle life performance. We employ atomic-level coatings on LCO to provide novel multifunctional and/or enhanced performance. Data projections for a resultant battery system using HV-LCO exceed performance metrics for electric drive vehicle batteries, with a competitive cost per energy density. Figure 1 shows scanning electron microscopy (SEM) images at 50Kx (magnification) for (a) pristine LCO and (b) atomic-level, metal fluoride coated LCO powder particles. Figure 1b shows a uniformly distributed, nano-sized metal fluoride coating on LCO, which is in clear contrast to the pristine LCO sample without ALD coating (Figure 1a). We evaluated the electrochemical cycle stability of coated and baseline LCO cathode samples against lithium metal anodes in coin cells (Li/LCO half coin cells) between 3V and various upper voltages, at C/2 rate and at room temperature (RT). When cycled between 3 – 4.6V (representing a 100% state-of-charge, SOC), the ALD coated LCO delivered > 220 mAh/g specific capacity and > 900 Wh/kg specific energy (based on the cathode active mass), which are substantially higher than SOA cathodes for Li-ion batteries. For example, the specific energy of the HV-LCO represents more than 50% increase over LiNi0.8Co0.15Al0.05O2 (NCA), one of the highest specific energy cathode materials. Figure 2 shows that, when cycled between 3 – 4.55V (representing > 90% SOC), the baseline LCO cell experienced a fast capacity fade vs. cycle number. On the other hand, the ALD metal fluoride, metal phosphate and lithium metal phosphate coated LCO cells demonstrated very little capacity fade when cycled to the high, upper voltage. Our study shows that the nanoscale, multi-functional coatings on LCO afforded substantially increased energy density and much improved high voltage cycle stability for the resultant HV-LCO. Coupled with economically scalable coating processes, the significant energy density gain of the HV-LCO renders the cathode material cost competitive in terms of $/energy density over SOA cathodes. Hence, our HV-LCO represents a promising cathode material for high energy density, long cycle life and cost effective Li-ion batteries that is ideally suited for many high energy density-demanding applications such as, electric drive vehicles, consumer electronics and other military applications. References Z. Chen, W.Q. Lu, J. Liu and K. Amine, Electrochimica Acta, 51, 3322 (2006). Jan N. Reimers and Dahn, J. Electrochem.Soc. 139, 2093 (1992). G. G. Amatucci, J. M. Tarascon, and L.C. Klein, J. Electrochem. Soc. 143, 1114 (1996). Hisashi Tsukamoto, Clay Kishiyama, Mikito Nagata, Hiroshi Nakahara, and Tiehua Piao, US6596439. Figure 1

科研通智能强力驱动
Strongly Powered by AbleSci AI
科研通是完全免费的文献互助平台,具备全网最快的应助速度,最高的求助完成率。 对每一个文献求助,科研通都将尽心尽力,给求助人一个满意的交代。
实时播报
刚刚
上岸发布了新的文献求助10
刚刚
云槿完成签到,获得积分10
1秒前
橙子发布了新的文献求助10
2秒前
xx发布了新的文献求助10
2秒前
2秒前
所所的应助被大气的fgyyhjj采纳,获得10
2秒前
xiaot完成签到,获得积分10
2秒前
徐长硕完成签到,获得积分20
2秒前
大模型的应助被故渊丶采纳,获得10
3秒前
3秒前
领导范儿的应助被欢喜若灵采纳,获得10
4秒前
大模型的应助被红雨灰衣采纳,获得10
4秒前
甜美山灵完成签到 ,获得积分10
5秒前
丘比特的应助被纯情的秋天采纳,获得10
5秒前
聪慧雪糕完成签到,获得积分20
5秒前
阳光的山水完成签到 ,获得积分10
5秒前
徐长硕发布了新的文献求助10
6秒前
ping发布了新的文献求助10
6秒前
LuXiaoyu的应助被oleskarabach采纳,获得10
6秒前
疯狂加载ing的应助被oleskarabach采纳,获得10
7秒前
牧百川发布了新的文献求助10
7秒前
8秒前
打打的应助被Felix0917采纳,获得10
8秒前
xiaot发布了新的文献求助10
8秒前
zzz发布了新的文献求助10
8秒前
9秒前
田様的应助被科研小白采纳,获得10
10秒前
tjzbw发布了新的文献求助10
11秒前
11秒前
研二就毕业完成签到,获得积分10
12秒前
晚霞跌落星河的应助被master采纳,获得30
13秒前
4yjmngbfd发布了新的文献求助10
13秒前
星辰大海的应助被稳重的馒头采纳,获得10
14秒前
16秒前
李健的应助被牧百川采纳,获得10
18秒前
风吹麦浪的应助被ping采纳,获得10
19秒前
天青色等烟雨完成签到,获得积分10
19秒前
vbmc发布了新的文献求助30
19秒前
英俊的铭的应助被张会采纳,获得10
19秒前
高分求助中
(应助此贴封号)【重要!!请各用户(尤其是新用户)详细阅读】【科研通的精品贴汇总】 10000
拉伸高分子熔体中缠结行为的模拟和小角中子散射研究 1700
The World Atlas of Wine 9th edition 1000
奈特基础组织学:配套组织病理学(第4版)(Netter's Essential Histology With Correlated Histopathology) 800
八旗制度の研究 600
Improving the wear resistance of vehicle gear oil by oil soluble LaF3 nanoparticles and typical additives of gear oil 500
Boundaries and Bodhisattvas 500
热门求助领域 (近24小时)
化学 材料科学 医学 生物 纳米技术 计算机科学 工程类 有机化学 化学工程 生物化学 物理 复合材料 内科学 催化作用 光电子学 人工智能 细胞生物学 无机化学 物理化学 数学
热门帖子
关注 科研通微信公众号,转发送积分 8183621
求助须知:如何正确求助?哪些是违规求助? 9572918
关于积分的说明 21828010
捐赠科研通 7780809
什么是DOI,文献DOI怎么找? 3434031
关于科研通互助平台的介绍 2558243
邀请新用户注册赠送积分活动 2480496