材料科学
腐蚀
涂层
镁
镁合金
压痕硬度
冶金
合金
扫描电子显微镜
衍射仪
电化学
核化学
化学工程
微观结构
复合材料
化学
电极
物理化学
工程类
作者
Motilal Lakavat,Amiya Bhaumik,Suman Gandi,Saidi Reddy Parne
标识
DOI:10.1088/2051-672x/ac68fd
摘要
Abstract This study examines the effect of nano Al 2 O 3 additions on the corrosion, wear, and hardness properties of an electroless Ni–P–B protective coating on AZ91D magnesium alloy. In this work, nano alumina particles with a diameter of 40–50 nm and a weight percentage of 1, 2, and 3% were used in an alkaline Ni–P–B electroless bath. The surface morphology of the nano-composite coating was studied by scanning electron microscopy (SEM) and the crystalline structure of the coating was examined by x-ray diffractometer (XRD). The inclusion of alumina nanoparticles, an electroless deposit produces a homogeneous coating on the AZ91D magnesium alloy surfaces. The experimental results show that incorporating 2 wt% alumina nanoparticles into an electroless Ni–P–B coating increases microhardness (986.4-VHN 200 ), specific wear rate (1.2 × 10 –10 Kg N −1 m −1 ) and has the lowest average friction coefficient (0.08) when compared to other coated and uncoated samples. Electrochemical polarisation and electrochemical impedance spectroscopic (EIS) tests in 3.5 wt% NaCl solution were used to investigate the corrosion resistance of various nano Al 2 O 3 additive Ni–P–B coatings on Mg alloy surfaces. Potentiodynamic polarisation studies show that 2 wt% of nano Al 2 O 3 incorporation in Ni–P–B coating on magnesium substrates has good corrosion resistance, with the coating resulting in the lowest corrosion rate (i corr = 1.47 × 10 –8 A cm −2 ) and the most positive corrosion potential (E corr = 0.55 V).
科研通智能强力驱动
Strongly Powered by AbleSci AI