This paper attempts to theoretically establish the technical possibility of manually controlling the tunnelling probability of phonons through potential barrier by superimposing Ultra High Frequency (UHF) acoustic wave over the source of phonons transmission, which results into Acoustically Augmented Phonons (AAP). Tuneable high fidelity acoustic piezoelectric transducer emitters may be used to tune the tunnelling. If the probability of reflectivity of phonon (P) during tunnelling through the potential barrier is given by P(R) p and that of Acoustically Augmented Phonons(AAP) is P(R) AAP then it is analytically obtained that P(R) AAP = ∝ P(R) P . Where ∝ is dimensionless number and is defined as the augmentation factor which is dependent on structure based damping coefficient, wave number of superimposed UHF acoustic wave and phonon's kinetic energy. Enhancement of tunnelling probability by mechanically superimposing UHF acoustic wave over the in situ phonons is independent of initial UHF acoustic wave's amplitude. It is noted that the range of 'tunnelling enhancement AAP's wave numbers' (or frequencies) gradually broadens with increase in the kinetic energy of phonons and also gradually tends to a limit. Thus, existence of almost zero reflectivity of tunnelling probability through the potential barrier by Acoustically Augmented Phonons (AAP) is theoretically obtained. A general observation is that to achieve very low reflectivity of phonon tunnelling probability 'structural damping factor' must be small enough than superimposed UHF of acoustic wave number.